GARY,
I just want to add a little extra confusion. When I fist came across the Yam Wire Diag. I went out and purchased
a BAL-XLR to PHONO cable. First thing I did was check the connections...&..they were / are exactly per Yam's diag...

I have that cable here in front of me, but of course I have never used it, because it doesn't work. I am really getting confused, because I have other Bal cables like this (not for Mic use, but con between Active speaks..& they are all wired per Yam's Diag.

The connection I currently use on T is wired as follows
XLR end.....*1-Gnd, *2-Hot, *3-Cold
Jack end....Gnd-Sleeve + Bridged to Cold which conected to centre ring.
....Hot to Tip

Let me add that this works as NORMAL...
on all my Yam's no buzz/hiss/dist/etc..except..VH on T which may be affected by this wiring...I wont know until I make nacessary changes per your instructions...As far as I'm concerned what you say makes sense, & gefore I ever got into this...I would have expected HOT to connect to Centre-Pin*3 of XLR...as you suggest.

So I'm off now to make up cable starting with Hot to *3 & we'll see what happens.

I wish I was a techi...'cause a little knowledge is a dangerous thing.

Talk to you again soon

Thanks
LeoD

P.S It's not that my spelling's sp bad..I just keep hittin' wrong Keys..same as on KBD

PS Again..The fact that Yam's Diag shows a Stereo Jack for input must suggest that not onlt 'T' but the other KBDs mentioned are fitted with a Stereo Jack Socket...Now we all know that a mono Jack works ...but surely YAM have a responsibilite..STEVE..to explain this to us all .



[This message has been edited by LeoD (edited 11-12-2004).]