SYNTH ZONE
Visit The Bar For Casual Discussion
Page 1 of 2 1 2 >
Topic Options
#36736 - 10/04/10 04:01 AM Audya after update
skude Offline
Member

Registered: 07/15/09
Posts: 388
My Audya plays a lot better after the big update BUT!
Left voice drops out, have to restart to get it back. It happens randomly. Before the update I had problems with "count in" this is now solved, ( it only took a year) but looks like this "virus" jumped over to the left sound. Have not had any Int. Phase error message for a long time. Saturdays gig went good except from drop out of left sound. Sometimes going from arr.C to arr.D, the drums are out of sync. on some styles. This is not fun happening in the middle of a song. Getting better in telling jokes to the audience.
In menu- utility- lyrics/txt small font, this is now working for the first time,set this to ON and I get small fonts.
Problems saving Vel. curve. I use Hard2, saving this, but it keep changing sometimes to normal, or soft1 or something else, you never know what it will show, annoying!!
The default Concert_Grand Piano at startup, has an annoying pitch on like the modulation wheel was turned on a little. If I used the Piano in program mode and set the MOD/WHA to OFF it's OK. don't know how to do that on a factory preset. May be it's suppose to be like that, but I don't like to have something that sounds like a vibrato to my piano. Very annoying. Most good, but some bad after the update. Still think there will be some time to go before I can fully trust this KB, may be after the next update.
skude

[This message has been edited by skude (edited 10-04-2010).]

Top
#36737 - 10/04/10 05:16 AM Re: Audya after update
kbrkr Offline
Senior Member

Registered: 11/19/02
Posts: 2866
Loc: Tampa, FL
Maybe we should keep a running list of fixed / outstanding issues to help Ketron.it resolve all of this.

Too bad Synthzone doesn't have "sticky" topics like some of the other Forums.

Al
_________________________
Al

Pa4x - LD Systems Maui 28 - Mackie Thumps

Top
#36738 - 10/04/10 06:58 PM Re: Audya after update
Ketron_AJ Online   content
Moderator

Registered: 03/21/01
Posts: 3583
Loc: Middletown, DE
skude,

I have asked some questions in your other post with regards to this left output issue. Please get some answers back to me...
http://www.synthzone.com/ubbs/Forum22/HTML/001609.html

Thanks.

AJ

[This message has been edited by Ketron_AJ (edited 10-04-2010).]
_________________________
[KETRON - USA]
Design Engineer & Product Specialist.
www.KetronAmerica.com

Top
#36739 - 10/05/10 12:41 AM Re: Audya after update
skude Offline
Member

Registered: 07/15/09
Posts: 388
AJ
This is not drop out of any output channel, it's just the left sound. (LEFT slider) Left/right and 3/4 outputs works fine. The left sound only drops out at startup, never during playing, or when changing regs, sounds or styles. It always comes back after a restart. Thanks
skude

Top
#36740 - 10/05/10 02:30 AM Re: Audya after update
audyaplayer Offline
Member

Registered: 09/09/10
Posts: 251
Loc: Holland
Hello,
Now i have the new sounds and reprogram my regs,there are some minor things that i have about the Audya,
1.slower when changing between the regs,when update 4.0 came,now even more
2.listen with headphone a lot of noise on reg,when you change reg,some are good and others have that noise,that high peep.
3.effects on programs are to much,when you change fast from one to another program there comes an high peep,because the hall effects are to long,they can close the parameter on time,i know you can change it and make it shorter,but you expect the factory does his homework proberly.
So i need a little bit longer time reprogamming on my Audya.
I do a lot of recording and that is immpossible with the Audya at this moment,to much noise and mess comes with it.
Audyaplayer.

Top
#36741 - 10/05/10 03:39 AM Re: Audya after update
skude Offline
Member

Registered: 07/15/09
Posts: 388
Audyaplayer
Sorry to hear about your problems. I notice it loads the regs slower than before, the other problems I don't have.
I have the Audya set up in my studio and doing some testing.
The vibrator I have on piano at startup, goes for all the pianosounds in the preset bank. If I change to another bank I.E. organ. Here are no problems, if I then goes back to the piano bank, the piano sounds are OK.
Then, as a test,I use the modulation wheel on a piano sound, the modulation does not go back to 0 again. A kind of vibrator will remain on the sound, just like it is at startup.
Yesterday I saved the Vel.Curve as Hard2 as custom startup. During saturdays gig it had changed to Normal. (not by me) Today, again I saved it as Hard2 custom startup, while playing it changed back to normal again. Did it over again, turned the KB OFF, at startup it was still on Hard2. For how long? It's very unpredictable. This KB sounds great, but if all these minor issues were solved I would feel a lot better. Anyway, after the update it's like a new world to me compared to the previous 12 months.
skude

Top
#36742 - 10/05/10 03:55 AM Re: Audya after update
NiteLife Offline
Member

Registered: 04/02/10
Posts: 264
Loc: Cape Coral, Florida USA
Skude & AJ:

Left channel out is still a problem with my Audya also!!!! It's not there about one out five times when keyboard is turned on.

This seems to be a fairly common problem.

Any answers or suggestions on how to correct this AJ?????????????????

Jim

Top
#36743 - 10/05/10 04:15 AM Re: Audya after update
audyaplayer Offline
Member

Registered: 09/09/10
Posts: 251
Loc: Holland
Hey Skude
We have all different problems,hard to believe,the Audya has is own life,i have one question for you,can you tell me where i can find the button for autocrasch,in the style Shadows is an crash,livedrums and drums are 0,and always that craschsymbal every time,the sd1 had an autocrasch you could turn off.I looked everywhere,but no autocrasch on/off.
Audyaplayer.
Audyaplayer.

Top
#36744 - 10/05/10 04:38 AM Re: Audya after update
audyaplayer Offline
Member

Registered: 09/09/10
Posts: 251
Loc: Holland
Skude,
are you using regs,look inside,have you in the past made regs with different vel.curves,
Are you saving the vel.curve with custumvoice,but when you change reg and there are different vel.curves that is maybe the problem.
Audyplayer.

Top
#36745 - 10/05/10 07:22 AM Re: Audya after update
skude Offline
Member

Registered: 07/15/09
Posts: 388
Quote:
Originally posted by audyaplayer:
Hey Skude
We have all different problems,hard to believe,the Audya has is own life,i have one question for you,can you tell me where i can find the button for autocrasch,in the style Shadows is an crash,livedrums and drums are 0,and always that craschsymbal every time,the sd1 had an autocrasch you could turn off.I looked everywhere,but no autocrasch on/off.
Audyaplayer.
Audyaplayer.


Audyaplayer
Only Autocrash I know about is in Style-Mode-page2, probably not the one you're looking for.

Top
Page 1 of 2 1 2 >

Moderator:  Admin, Kerry, Ketron_AJ, Tonewheeldude 



Help keep Synth Zone Online