Registered: 06/30/01
Posts: 461
Loc: Dallas Tx., USA
I'm having problems[Maybe?] with the PSR3000, When I turned it on it stays in the initial screen, and reads as follows: "Owner Name".... What do I need to do?
Registered: 04/28/06
Posts: 807
Loc: North Texas, USA
Vincent, I have a Y3K and thankfully never had this problem. I presume you bought this used from a private party. I would start by making sure nothing is in the media card slot.
If that fails, you will have to go to your nearest Yamaha dealer. Try swapping the power supply with another one that you know is good.
If the problem is not the power supply, you might try downloading and reinstalling the Operating system. To do this you will need a media card. They are hard to find in stores, I suggest getting one from ebay.
If all else fails, it will have to be opened up. Maybe a circuit board became unseated during transit. You could try yourself, or rely on the nearest service center.
#212035 - 08/11/0709:10 PMRe: I received my PSR3000 today, I need help..It's Urgent!
Scott Langholff
Senior Member
Registered: 06/09/02
Posts: 3163
Loc: Pensacola, Florida, USA
Oh, I just reread your post. You say it stays in that screen.
A factory reset should take care of it. While the keyboard is off press and hold the highest white key (C) and continue to hold it down after turning it on. This is the factory reset and in most cases solves all problems.
Registered: 06/30/01
Posts: 461
Loc: Dallas Tx., USA
Quote:
Originally posted by Scott Langholff: This is normal, this is the way it will be until you put your name in there. Nothing urgent about this. I'd imagine a lot of people never do it.
Go to Function>Utility>Owner>Owner Name. Type it in, hit OK.
It was urgent because I had to use it in a church service last night....
Registered: 06/30/01
Posts: 461
Loc: Dallas Tx., USA
Quote:
Originally posted by Scott Langholff: Oh, I just reread your post. You say it stays in that screen.
A factory reset should take care of it. While the keyboard is off press and hold the highest white key (C) and continue to hold it down after turning it on. This is the factory reset and in most cases solves all problems.
I tried that before asking for help here....it's not doing nothing,,,
Registered: 06/30/01
Posts: 461
Loc: Dallas Tx., USA
Quote:
Originally posted by Dnj: where did you get this KB?
From a SZ member.
I tried to call him but he's not answering, As far as I know he's well known here and a good guy, I'm thinking he's not home, he usually answers the phone or e-mail on time.
Registered: 06/30/01
Posts: 461
Loc: Dallas Tx., USA
Quote:
Originally posted by ViLo: From a SZ member.
I tried to call him but he's not answering, As far as I know he's well known here and a good guy, I'm thinking he's not home, he usually answers the phone or e-mail on time.
Thanks.
The keyboard stays in the initial screen, and I can barely see the letters: "Owners Name:"
Previous Topic
Index