Another thing to remember is that if you should execute an 'Initialise / Performance' operation, this will reset the Footswitches back to their default condition, even if the 'Data Protection' is set to 'ON' for this function. You will then have to go through the process of setting up your Footswitches again, which can be a 'bit of a pain' especially if you use FS1, FS2 and the 4 way footswitch unit. The way I get around this, is to store the settings in 'Custom Panel' and then immediately after Initialising, I just press 'Custom Panel' and Voila!! they return to my chosen setup.
This refers to a KN7000 - not sure if it applies to the KN2400

------------------
Willum
_________________________
Willum

After silence, that which comes nearest to expressing the inexpressible is Music.
Aldous Huxley
( especially when the music is played on a KN7000....)