Hi Fellow Arranger Players:

I took my PSR-2000 out of "mothballs" yesterday after a request by my wife to begin using it as a piano. I upgraded to a PSR-S910 about a year or so ago and kept the 2000 as a backup.

To my surprise, after unpacking and setting the old warhorse up again, no sound would come out of the speakers. I quickly plugged in the earphones and everything sounds fine in that mode. I pulled out the manual and read until my eyes complained and found nothing definitive. I then resorted to a factory reset. Same problem still exists. Is it possible that when I was using this as my primary music maker and recording while listening to headphones (never used the speakers with a few exceptions)... that the contacts inside the jack will not return to a state to allow the speakers to receive a signal.

Any ideas or suggestions will be appreciated.

Thanks,

Dave Rice
Songwriter