The Situation re registrations is basically that in X1 there are four "locations"
1 Presets =not changeable
2 Factory presets which you can edit eg sounds tempo etc. Edited factory settings are not registrations as such but they are a convenient place to arrange things eg I use 01A with a banjo pickin to replace guitar and I use appropriate tempo but I then store it as a "full" registration in either Block or Single reg.
3 Block registrations are 99 bank A plus 99 bank B ie 198 registrations ( more than adequate for anyone ??. Here all settings I need are registered. IE 33 is waltz and when I press it I start to play without any adjustement of anything incl volume as compared to another reg ie all regs have a balanced volume to suit on the road work.
4 Single Regs are the same but they have the advantage that they can call up the words of the song fron disk or a programme of waltzes etc.Also you can store approx 100000 single regs ie if you had 100000 songs and wanted to have special regs for each you could do so and when you give same name to text file as to reg the words of the song appear.In practice it seems unnecessary to have that many as I ue about 60 and I think that s alot.
If you have single reg and you wish to store it as block reg you simply save it after selecting block reg. This would mean that you would have it twice. Block regs load at a press (less an almost unnoticeable fraction of a sec delay whereas single regs are from hard drive and may take a second approx.
So if you have a reg in block and you want to save it as single simply enter utilities and select single and save it. Bear in mind that you are saving settings from the Board not from another reg. which means that if you delete or change a block reg which was used as a basis for a single reg you (gladly) are not deleting your single reg.