Originally posted by loungelyzard:
...Not to swift on these things myself, but maybe on the output of the little amp a pot to lower the output? or on the input side to lower the signal to amplify???
Sounds like you had fun though.....Pose
Yes, a poti between line-out and ground. So the poti's slider represents the new output (I recommend to buy a
stereo-poti)...
This is the more comfortable solution.
You can also solder a little resistor to each of the stereo line-out channels (100 ohm might be enough if not, try higher values) to damp the signal just a little bit (like it was done with older headphone outputs). This is the cheaper solution.
------------------
Greetings from Frankfurt (Germany),
Sheriff ;-)
Previous Topic
Index
