Here is the 3rd installment that gives you step-by-step instructions on using ACOURATE.


https://bit.ly/4jczK16


Using Acourate to Generate FIR Filters.pdf


You would begin with the Measured Impulse Response curves of your Left and Right Channels.


You would analyze the measurements and design a Target Curve.


Next, you would run through the Macros and Test the Convolution.


If the Predicted Impulse Response curves from your Test Convolution are not to your satisfaction, you would start again with a different Target Curve.


Finally, you would generate the FIR Filters.


The next article will show you how to import these FIR Filters into ROON’s Convolution Engine.