Here is the 5th Installment.


https://bit.ly/4jczK16


Verifying the Measurements in REW.pdf


When you run a Test Convolution in Acourate, you get a plot of the Predicted results.

It is always a good practice to verify the Predicted results with the Measured results in REW after engaging the FIR Filters in ROON.

To do so, you need to play back the Test Tones through ROON with the Convolution Filters turned on.

Generate WAVE files of the Sweeps of the Left & Right Channels and add them to your ROON music library.

Take measurements in REW. However, mute your PC speaker this time. The reason being you do not want your microphone to respond to the internal test tones from REW. Rather, you want your microphone to listen to the Test Tones being played back by ROON after being passed through its Convolution Filter.

In the next article, I will leave my closing thoughts along with references to additional articles by industry experts for further reading.