Larry H.

Thanks.

After getting completely set up to record I then:

Record each part via the sequencer in real time (I do not use the Easy Record method).

I usually record about 8 to 16 bars each time for each part. An 8 bar passage will usually take 2 to 5 parts to be recorded. After completing the passage, I will then advance to the next Panel Memory to set the applicable parts, and probably also change the Rhythm setting to match the next passage.

Sometimes there is some editing necessary to do. If possible I do this in real time using the Sequencer, by setting the sequencer to the specific bars or measures that I need to edit. Sometimes I can do the edit by merely changing the specifics of a note or two by using Step Record method.

After the song recording is done, I will usually do a complete review of the song and finish up with any further editing, changing, re-recording, etc., that I feel will improve the arrangement.

The editing is made easier by keeping complete documentation of all recordings, settings, etc., as I progress through the various recording passages.

Hope this helps a little.

Thanks again.

Larry G