Hi,
I have recently purchased a Ketron SD2 and a Fatar (Studiologic) VMK-188 Plus as a keyboard controller.
I have worked out how to access the sounds in the SD2 (pages 37-40 of the SD2 manual) - good!
I have also finally manged to activate the organ drawbars & percussion on pages 42 & 45 of the SD2 manual using Bank MSB = 67.

However I simply can't activate the Rotor settings on page 42 nor the Reverb, Distorsor settings on page 44. via the slider, knob, button on or pedals connected to the VMK.

A critical task to get this rig setup for live playing is to get the rotor/leslie working via one of the pedals attached to the VMK workstation.
The pedal programing on the VMK allows me to set the following parameters:
* Midi Channel (number)
* Control Change (number)
* Min & Maximum values (0-127)
* Polarity (of the pedal).

I note in the SD2 manual it says:
CONTROL 1EH Bnh 1EH
00H = rotor OFF
40H = rotor slow
7FH = rotor fast

How do convert the above SD2 codes into VMK Midi Channel, Control Change & minimum and maximum values?

Thanks for your help

------------------
Nigel Spiers
Blues and Views