.


Thanks for the speedy response, Bob and Ray,

I have followed your advice, and 'scissored' two floppy disk labels to a slightly smaller size than the SD Cards. Stuck them on, and just used two-letter 'Identifiers' .... 'ST1' = Styles Card 1, 'BA1' = Backing Trax 1, etc.. I found it easier to draw round the SD card with a pen, then write the title', before cutting them up, a tad smaller than the card. And as Bob suggests, stuck them on to the plastic, rather than over the existing brand labels.

Better run off quickly to the bathroom, Ray - you look as if you are 'bursting' - LOL

Cheers & Beers,

John (Always fiddling with something !!)

.