http://tcsupport.custhelp.com/cgi-bin/tc...3673281&p_olh=0


The latest version of Harmony-M software is v1.1 build 17.

You can see what version your Harmony-M is by holding the Voice1 and Voice2 buttons while powering up the unit. The Preset display will show the build number as a single digit with a dot to signify 10+(number displayed). Newer versions from the factory will show 7 dot.

If you have any other version, you can upgrade to the latest version and gain the improvements listed below.

Improvements in Harmony-M v1.1 Build 17:

* Chord detection speed improved by 60%
* Bass Voice follows chords better
* Exiting Bypass now done with tapping instead of holding On button
* Harmony On/Off activates on footswitch press instead of release

Instructions:

You will need a computer, a MIDI sysex application and MIDI interface. There are free sysex applications available on the web by searching MIDI Ox (PC) or Sysex (Mac).

* Download the sysex file attachment below to your computer.
* Power up Harmony-M
* Connect a MIDI cable between the MIDI Out of your interface to the MIDI In on Harmony-M.
* Load the included sysex file into the sysex application.
* Send the sysex file. Harmony-M's Input LED (beside the Input control) will light during the dump.
* After a short time, the sysex dump will complete and Harmony-M will automatically reset and restart with the new software.
* Check the version as described above to confirm it is correct.


[This message has been edited by ocomain (edited 11-05-2008).]

[This message has been edited by ocomain (edited 11-05-2008).]