keybplayer

You are partially correct (on working for/with CMC distributors in the US).

Here is the other 1/2 of the story you apparently might not know...

1. I do work for Ketron.
2. I am (very) limitted by Ketron as to the information I can disclose on any open forum as an Engineer because as you'd understand our competition also monitors these. This is especially true for developing projects!
3. Despite the limitations, I still try to give the public the best info I can (without crossing company lines). I write the brochures (and will do the manual) so before it is made public, ofcourse I've had access to the material, prototypes ... etc.
4. If the information I provide is not enough, at the back of most/all Ketron brochures is a (039 ...) number you can call or email ketron@ketron.it (the emai will eventually end up in my laps anyway so I suggest you use the phone) and attempt to get more info.

Hope this makes it a little better to understand.

AJ

[This message has been edited by Ketron_AJ (edited 05-30-2007).]