The section of push buttons that select registrations (1-8)on my 9000 Pro have me concerned. The left end of the strip is ok being flush with the slot in the cover which allows the buttons to stand slightly above the surface of the top cover. But, going toward the right the strip of buttons get gradually lower until #5& #6 are about even with the top surface of the cover and #7 is slightly below and #8 is very much below. The strip of buttons do not seem to be lose. When I try to pull up they will not move. I'm wondering just how to view this. They seem to make proper contact and work the way they should. However, it feels a bit strange when pushing the right end buttons to hit the case cover also. Plus, something must be amiss to allow that whole end to drop down. Did some little nut or fastener drop off and is now waiting to end up somewhere that will cause further problems? What to do, What to do?
DVJ