Hi all,
Loving my 9000pro BUT I need a bit of help here.....

In the mic setup window I make my adjustments (ie adjust noise gate from default -45db to -55db otherwise I tend to get cut out at the end of a vocal phrase) all well and good. Now how do I save this setting so that when I next turn on the board the noise gate (or whatever I changed) stays at my settings? I did try saving the setup in a registration memory and when I select the registration after a new boot it does change certain settings to my prefrences but the noise gate always resets itself to default.

Am I missing something here? I cannot find in the manual a way to achieve this! Any help would be much appreciated

Many Thanks
Tony W



[This message has been edited by Tony W (edited 11-19-2002).]

HI: Tony
I don't know if this will work or not but did you try
to do a backup after you set the noise gate to
what you want ? By pressing the ( A ) button
then the ( G ) button. I think this is the right buttons
if memory serves me right. I'm not at my PRO now
other wise I would look to be sure.
It might work !!!!!!!!!!
I hope this works for you.
Denny

Hey Denny
YOU DA MAN !!!!!!

Yes it worked brilliantly. Many many thanks. You would not believe how many days I have been trying to figure this out. I knew there must be a way.

Thanks again
Tony W

Tony glad to hear it worked.
Enjoying the 9000 PRO
Denny