Hi All,

At the kn7000, Can the monitor off status be saved, so that when turning off and on the kn7000, the monitor off can be recalled in a push of one button?

Thanks,
Doron

yes, in custom panel set to all mode.

Hi Technicsplayer and all,

I tried the instructions below in the following order:

1. I changed the Custom panel to all mode

2. Set the monitor speaker to off.

3. Saved the setting in the custom panel by pressing the Custom panel while SET is pressed

4. Turned off the kn7000

5. Turned on kn7000 after 3 minutes.


After doing all the procedure above I observed that monitor speaker was "ON" even after I recalled the previous setting by pressing the custom panel button.


Do I need to add any additional steps?


Thanks bunch,
Doron

sorry I misunderstood, I have the output parts permanently connected to studio MONITOR speakers, and the sub out part settings for this can be saved and recalled in the custom panel. The MONITOR setting to disable the internal speakers cannot be saved - but you could use the old fashioned method and just leave a blank jack in the headphone socket!

Thanks very much for the clarification!

Kind regards,
Doron Peisic