I want to load ver 1.5 into my KN7000 but I can't remember which keys to hold when switching on the power.

Can anyone help?

Thanks,

Larry G

Larry,

There have been reports that version 1.5 can cause crashes in the KN7000 if you have any expansion boards installed. Version 1.6 is supposed to resolve the problem.

There was a long thread about this version in Jan 2003: http://www.synthzone.com/ubbs/Forum25/HTML/002036.html

From technicsplayer (addressing a different Larry!):



Mark.



[This message has been edited by MarkW (edited 02-06-2004).]

I do not have any expansion boards installed.

My problem is that frequently when I turn on the power, only the blue light in the SD comes on, but not the remainder of the KB.

Sometimes, the KB will shut down in the middle of playing a sequenced song.

I have ordered ver 1.6 and will install it when it arrives. Hope this might help the problem.

I though that maybe reinstalling ver 1.5 might set the Operating System back to where it should be. I just can't remember which keys to hold down when turning on the power.

Thanks,

Larry Gosmeyer

1st four panel memories, but remember to perform the disk check it offers you every time you attempt you load a system.