I received this message from Roland Schmid (Keysoftservice) :

"I am working to get both code in one new version.
Unfortunately the is still a very small "bug" in but you can try the attacked version . Sometimes a Debug windows appear if you select HARD DISK MAIN MENU.
Simply press than EXIT and the same procedure again.

Hope to have next week ab better version without that bug!

Best regards "

I received a new version to try and untill now I have no problems.

Greetings ,
Alain

I wish that roland could tell me when
I can order SOMEWHERE the HDtechmanager
for my HD-sx6.
And: I registered my HD-sx6 but never
got an reply
And: I have a terrible website, but....
Roland only knows one word: "Under construction"....
I shall never understand it: I want to buy software and no one can deliver it and...
most important....no one seems to care about
it...
Wim

I too have regestered my HD 6. Never heard a word. The web site is useless and should be closed until construction is completed. Would love to ask questions and develop a relationship with the company. Afraid it's not going to happen under current management. Leaves me uneasy should I have problems.

Hi Alain
And what does the new version do? I have the 1.3 and it works fine. In the 2.0 there was some bugs.
Lindoz

Now I have version 1.13 installed but in order to use the hdtechmanager6000 I had to install version 1.2 otherwise the parallel port will not be recognized.
When you play the keyboard you need to reinstall version 1.13 otherwise you will have problems when you load data from the harddisk.
They admit this is a bug...so they are working to eliminate this bug.
The new version a received from Roland Schmid is a beta version.
Greetings,
Alain

Yes Alain
Of course I mean the 1.13 ver and the 1.2. So I understand that Roland talks about the 1.2 ver, which I found have some bugs.
Lindoz

you only need to change 1.13 if you use the techmanager, at this point in time.