SYNTH ZONE
Visit The Bar For Casual Discussion
Page 2 of 2 < 1 2
Topic Options
#31616 - 01/29/05 06:21 PM Re: New upgrade for the SD1
DonM Offline
Senior Member

Registered: 06/25/99
Posts: 16647
Loc: Benton, LA, USA
My SD1 has 4.0a installed. I try to install 4.0c and it locks up. Is it necessary to first install 4.0b or is it possible to install 4.0c over 4.0a?
Thanks,
DonM
_________________________
DonM

Top
#31617 - 01/30/05 03:18 AM Re: New upgrade for the SD1
Gunnar Jonny Offline
Senior Member

Registered: 04/01/01
Posts: 4084
Loc: Norway
Don, I'm maybe totaly out on the fields here, but I seem
to remember looking into the website that there are two
different updatefiles, one for SD1 and one for SD1+.
Just striked my mind if there could be a mixup in files
downloaded?
GJ
_________________________
Cheers 🥂
GJ
_______________________________________________
"Success is not counted by how high you have climbed
but by how many you brought with you." (Wil Rose)

Top
#31618 - 01/30/05 09:26 PM Re: New upgrade for the SD1
Henry01 Offline
Member

Registered: 03/06/01
Posts: 130
Loc: Dublin, California, USA
Don,

There are 3 versions of 4.0c for the SD1. On the Ketron download page, if you scroll down a little bit to the 4.0b release, you will see a better description of the 3 different versions.

(1) SD1ORG_40C.exe
(2) SD1STN_40C.exe
(3) SD1PLS_40C.exe

Assuming you have 4.0a installed along with the 4.0 new sounds. Then you should download file number (2), SD1STN_40C.exe. Once the file is downloaded, run it (SD1STN_40C.exe) on your PC and unzip the content onto a formatted floppy disk. Take the floppy disk and insert it into your floppy drive in the SD1. Turn on the SD1 while holding down F6. It should load all the files and update your SD1.

If this still fails, you might need to load 4.0a again. Download all 12 files and follow the 4.0a instruction on the website.

Henry

Top
#31619 - 02/02/05 06:34 PM Re: New upgrade for the SD1
DonM Offline
Senior Member

Registered: 06/25/99
Posts: 16647
Loc: Benton, LA, USA
Thanks for the help. I've been so busy that I haven't taken time to try again yet, but I will soon.
Don
_________________________
DonM

Top
Page 2 of 2 < 1 2

Moderator:  Admin, Ketron_AJ, Tonewheeldude 



Help keep Synth Zone Online