SYNTH ZONE
Visit The Bar For Casual Discussion
Page 2 of 3 < 1 2 3 >
Topic Options
#311249 - 06/12/10 11:30 PM Re: Screen Back-light
Tony Hughes Offline
Senior Member

Registered: 01/30/06
Posts: 3944
Quote:
Originally posted by Irishacts:
Ok it's a G084SN01-2.

Must see if there is software or a pot that can be adjusted.

Cheers
James.


James,

Maybe this is the cheapest screen known to mankind and does not adjust at all, the vga socket for the external screen will no doubt adjust, or the external screen will, after all the 9" touch screen will be the most expensive bit of kit in the MS for Dom to buy in!
_________________________
Tyros 4/Pair SR 350/ PC with a i8 intel chip, XENYX 802, Ford Focus 2 litre/Tascam DR07/Brother printer/Designjet 500/ our Doris/5 Grandchildren/ white boxers short Kymart shipped over and Typhoo Tea Earl Grey

Top
#311250 - 06/13/10 02:40 AM Re: Screen Back-light
LIONSTRACS Offline
Member

Registered: 12/13/05
Posts: 664
Loc: Italy
Yes, is possible now setting the contrast and the all display features with the PCIExpress VGA card, BUT: need to connect one small OSD PCB controller.
the OSD PCB controller is the same as the standard TFT display, where give the key: SETUP, Auto ADJ, +, -, Enter.
On the Groove Keyboards on rear side we have included ONE small witch for make the Auto Adjust TFT, BUT on MS cases ( developed many years ago) do not give one hole available for insert this AUTO Adjust switch.
Also on new Groove is not developed for support the 5 switch setting, just one in replace of the VGA out connector of the PCIExpress Card.
On request, I can shipping the OSD controller BUT then you have to open the TOP of the MS for make the setting.
After saved the new settin remain on Eeprom status.
Before we shipping the PCIVga, we just run it and auto adjust for the first setting, this is enough.

Top
#311251 - 06/13/10 02:59 AM Re: Screen Back-light
AFG Music Offline
Member

Registered: 03/12/09
Posts: 513
Quote:
Originally posted by LIONSTRACS:
Yes, is possible now setting the contrast and the all display features with the PCIExpress VGA card, BUT: need to connect one small OSD PCB controller.
the OSD PCB controller is the same as the standard TFT display, where give the key: SETUP, Auto ADJ, +, -, Enter.
On the Groove Keyboards on rear side we have included ONE small witch for make the Auto Adjust TFT, BUT on MS cases ( developed many years ago) do not give one hole available for insert this AUTO Adjust switch.
Also on new Groove is not developed for support the 5 switch setting, just one in replace of the VGA out connector of the PCIExpress Card.
On request, I can shipping the OSD controller BUT then you have to open the TOP of the MS for make the setting.
After saved the new settin remain on Eeprom status.
Before we shipping the PCIVga, we just run it and auto adjust for the first setting, this is enough.


Domenico maybe on MS you can use one of the PCI card hols for that switch you used on Groove, if is possible.

[This message has been edited by AFG Music (edited 06-13-2010).]

Top
#311252 - 06/13/10 06:03 AM Re: Screen Back-light
Irishacts Offline
Senior Member

Registered: 11/18/01
Posts: 1631
Loc: Ireland
Hi Domenico.

You mention contrast, but we are talking about the actual brightness of the Back Light.

Does this OSD controller modify the actual brightness of the back light?

If so this is something I would like to have because the display is very dim. Would any controller work here or do we have to use the very specific one that you didn't include with the screen?

Kind Regards
James.

Top
#311253 - 06/13/10 11:55 AM Re: Screen Back-light
miden Offline
Senior Member

Registered: 01/31/06
Posts: 3354
Loc: The World
Yes I would like the controller as well.

It could easily be mounted inside the case with a small mod to enable exterior control.

Dennis

PS: On second thought, and re-reading your post Domenico....I already have the new nVidia PCIe card you sent recently....

I did use the Auto Adjust button attached to it. Is THAT the control you refer to?

Is there some other control we can use to increase the brightness?

[This message has been edited by miden (edited 06-13-2010).]

Top
#311254 - 06/13/10 12:55 PM Re: Screen Back-light
AFG Music Offline
Member

Registered: 03/12/09
Posts: 513
Domenico,James,Dennis:

if possible maybe you can use one of the PCI card hols, becouse on MS is only one PCI card hol used.

Top
#311255 - 06/13/10 01:13 PM Re: Screen Back-light
Tony Hughes Offline
Senior Member

Registered: 01/30/06
Posts: 3944
Quote:
Originally posted by miden:
Yes I would like the controller as well.

It could easily be mounted inside the case with a small mod to enable exterior control.

Dennis

PS: On second thought, and re-reading your post Domenico....I already have the new nVidia PCIe card you sent recently....

I did use the Auto Adjust button attached to it. Is THAT the control you refer to?

Is there some other control we can use to increase the brightness?

[This message has been edited by miden (edited 06-13-2010).]


Dennis,

Take it easy this could end up with Franks hammer and chisel on the job, cheaper to buy a dimmer and turn to room light down.
Will mine of all the bells and whistles, I have warned our local power station to get ready with another generator on standby with all those LEDS when I turn the MS on.

Cheers Dennis
_________________________
Tyros 4/Pair SR 350/ PC with a i8 intel chip, XENYX 802, Ford Focus 2 litre/Tascam DR07/Brother printer/Designjet 500/ our Doris/5 Grandchildren/ white boxers short Kymart shipped over and Typhoo Tea Earl Grey

Top
#311256 - 06/13/10 01:51 PM Re: Screen Back-light
miden Offline
Senior Member

Registered: 01/31/06
Posts: 3354
Loc: The World
Quote:
Originally posted by AFG Music:
Domenico,James,Dennis:

if possible maybe you can use one of the PCI card hols, becouse on MS is only one PCI card hol used.


Yes AFG it could, but I would discount them as the are too big for the size of the reset button. It is a very simple matter to drill a small correct sized hole on the far left (looking from front) where there is ample room both inside and on the rear panel.

As I said in my postcript to my last post...I may not need to as perhaps this reset control is already on the pcie express Nvidia card I just bought and installed, a couple of weeks back.

In that case its a "once only" reset button as the settings are then stored in bios after the one press.

Dennis

Top
#311257 - 06/13/10 01:53 PM Re: Screen Back-light
miden Offline
Senior Member

Registered: 01/31/06
Posts: 3354
Loc: The World
Quote:
Originally posted by Tony Hughes:
Dennis,

Take it easy this could end up with Franks hammer and chisel on the job, cheaper to buy a dimmer and turn to room light down.
Will mine of all the bells and whistles, I have warned our local power station to get ready with another generator on standby with all those LEDS when I turn the MS on.

Cheers Dennis


LOL!!! No need to take it easy...I have a very good idea of what I am doing Tony

Having refurbished a few PA1s and a Pa2x...And converted a M-Audio Keystation Pro 88, to a 73 note keyboard....and modified quite a few other things....

Creating a small hole for such a control is a walk in the park

Dennis

Top
#311258 - 06/13/10 09:14 PM Re: Screen Back-light
Tony Hughes Offline
Senior Member

Registered: 01/30/06
Posts: 3944
Quote:
Originally posted by miden:
LOL!!! No need to take it easy...I have a very good idea of what I am doing Tony

Having refurbished a few PA1s and a Pa2x...And converted a M-Audio Keystation Pro 88, to a 73 note keyboard....and modified quite a few other things....

Creating a small hole for such a control is a walk in the park

Dennis



Dennis,

Have you any photos of the PA2x with the top off, I have one, just interested,whats the build qualilty like, appears to me they are all missing a set of hinges, photos of the MS show bits of wood to hold the top up.

Regards

Tony

[This message has been edited by Tony Hughes (edited 06-13-2010).]
_________________________
Tyros 4/Pair SR 350/ PC with a i8 intel chip, XENYX 802, Ford Focus 2 litre/Tascam DR07/Brother printer/Designjet 500/ our Doris/5 Grandchildren/ white boxers short Kymart shipped over and Typhoo Tea Earl Grey

Top
Page 2 of 3 < 1 2 3 >

Moderator:  Admin 



Help keep Synth Zone Online