Hi John,

I just recorded a song on the KN-7000, and then went through all the steps to convert the Technics file to a GM.

I'm not sure what happened, but the voice changes for the right hand never converted properly. On the original Technics sequence the right hand voice was a violin, but after converting to a GM, the violin was now an organ2 and remained an organ2 throughout the midi song even though I switched voices throughout the original Technics recording.

I also used pads that were never copied from Technics to GM, leaving a gap where the pads were used. I'm not sure what happened to the pads.

I use VanBasco, and is a great free program, but I use Cakewalk Home Studio 2004 for editing midis. I have it set up with the file names for a Yamaha PSR-3000, where I can make voice changes easier than on a keyboard. I'm not sure if there are any KN-7000 definition files for Cakewalk.

------------------
Larry
SynthZone Map

[This message has been edited by lahawk (edited 03-22-2008).]