Hi Larry,

Video out on the KN7000 is via a female RCA type connector. You need to connect to a video input connector on your TV which probably has the same type of connector. Thus you need a Male RCA to Male RCA type cable. These are best kept reasonably short (6 to 8 feet). Longer cables can be used (I have used up to 30 feet) but some degradation of picture quality may be observed. Suitable cables are available from suppliers such as Radio Shack. Audio will need to be connected separately from the main out terminals on the KN7000 to the audio input on the TV. Main out audio terminals on the KN are 1/4" phone jack. Audio input terminals on the TV again are probably female RCA type. For mono TV you would require a 1/4" phone plug to RCA male type cable connected from the R/mono main output on the KN to the audio input on the TV. For stereo TV you will require 2 such cables connected from left and right main outputs on the KN to left and right audio inputs on the TV. Again suitable cables should be available from Radio Shack or similar. European type sets often use a Scart type connector for audio and video inputs. These require a different cable. Hope this is of some use.

Cheers
Len C.

PS Due to low resolution used on the KN picture quality is not overly impressive on a large screen and does not cover the full screen area.

[This message has been edited by manorcourt1991 (edited 09-15-2003).]