Quote:
Originally posted by Bill Norrie:

If you have a set of panel memories already set up in one of the 1 to 10 Banks and wish to transfer this Bank to Bank A, B, or C, then you can do this by following these steps. It's a bit of a long winded process, but unless someone knows differently, I think it's the only way.

1. Press 'Bank View'
2. Select Page 2.
3. Select the memory bank you wish to transfer (Copy)
4. Press Panel Memory 1 to recall the settings
5. Select Page 1 and the Bank (A, B, or C) to receive the copy
6. Press and Hold 'SET' and then Panel Memory 1 to copy the settings.
7. Select Page 2
8. Select the memory bank you wish to transfer (Copy)
9. Press Panel Memory 2 to recall the settings.
10. Select Page 1 and the Bank (A,B, or C) to receive the copy
11. Press and Hold 'SET' and then Panel Memory 2 to copy the settings.
12. Repeat the process until all 8 Panel Memories have been copied
13. Save using '3BANK' or if desired, copy another setup from 1-10 to A,B,or C and then save.

Hi Bill
I feel you are right to say that your suggestion is a long winded process it carries too many unecessary button pushes.
I well remember that Alec answered this same question once before(I saved it)
just save all 13 panel memory banks & then use page 3 set to bank to load the bank you want to a different bank.