Dear Alec the punch in and out is not yet
solved with my kn6500 OOOOOOOPS!

In easy record mode or the other full
rec mode with APC on.When i record right1
wiht APC in punch it goes alright.Both APC
and right1 are recorded smutanously supose
from measure 1-10.but when i take session
from 11-20 with APC and right2 then sometime
it goes alright otherwise it gives the
message: "it is necessary to press rec-stop to complete the procedure" This message
comes in manual punch,And if i use auto punch
the message comes:"Punch out rec has been
unsuccessful because sequencer operation was
iterrupted befor the punch out measure was
reached"

Am i doing somthin wrong .Please tell
me about these messages in bit detail cause
i am new to KN.there is no mension about
these messages in the manual.

One more thing to go,the APC doese
not record simultanously with other parts
except R1 R2 why? it shoud be recorded
simotanously with ohter parts too.If there is
any way please tell me Thanks.PPPllleeaassee
help me out.