Hi Don.

Not enough info if your loading files with or without a sequence song. I do like to mention strange things do happen when loading files from and to different models, ex: KN6000 format loaded on a KN7000. Most areas affected are volume and octaves. That could be one reason.

With Sequencer:
The APC Volume of 127 is set in the Sequencer memory at start up. Which is why your getting 127 after loading.

Load the style/song
Adjust APC volume to 111
Go to Sequencer, and press Panel Write.
Save and re-load to check. (Make sure when saving you include the sequencer)

Without Sequencer:
In this case, the APC Volume of 127 is set in "Current Panel" at start up. Which is why your getting 127 after loading.

Load the style/song
Adjust APC Volume to 111
Save, re-load to check. (Make sure when saving you include the Current Panel)

Hope this helps... Anthony

[This message has been edited by AnthonyCian (edited 08-30-2004).]