A few more parts have arrived.

I'm trying to settle on the final layout for the prototype before I start cutting and drilling some sheet metal.

Here is the current button layout, with faders and drawbars added.

In this arrangement I have stacked the arranger controls into two rows, with the Fill buttons (4 x yellow) directly above the corresponding Variation buttons (4 x blue). The Break, Sync Start, Sync Stop, Fade In/Out, Chord Hold and Left Hold buttons are also in this second row
I have moved the Ending buttons (3 x red) over to the left, next to the Intro buttons (3 x green)



Overall dimensions of the control surface to accommodate all of the components are 1100mm x 310mm - without keyboards.

I'll need four panels:
1 - for the arranger controls, presets and drawbar base (bottom)
2 - for the screen and individual style and voice selection buttons (centre - tilted on an angle)
3 - for the style group buttons and style faders etc (left side, raised up and slightly tilted)
4 - for the part select, voice group, voice/part faders and master faders (right side, raised up and sightly tilted - to allow the drawbar arms to move underneath)
_________________________
My stuff - http://www.synthzone.com/forum/ubbthread..._Vir#Post422289