Hi Jim

You requested:-

Load some panel memories; save the file, and under save use Page 2 to specify saving ONLY Panel Memory data. Now, exit, try to LOAD, Page 3, and load a single or bank of Panel Memories back in . . .

I was able to load both single and bank without any problem.
Could I suggest that you try the same thing again, but this time make sure that you name each of the panel memories, so that you will be able to know for certain if they have loaded or not. Also make sure that you identify the FROM location and the TO location on page 3. e.g. you could load a Bank of Panel Memories from Bank 10 of your saved file and save them to Bank 1.
John