Hi all... long time no post....

I am finally getting settled into my new place in Plainville, KS and, after receiving my student loan refund check decided to make some new purchases to help in my transition, Yammie P-95 and Korg PA500 to replace the PA1x Pro that I had to leave behind at my last job.

Here is my question. I am planning on running the P95 as master and slaving the PA500 to it but I also have a Roland VK-8m module and need to make the P-95 master of the chain.

I did a trial run before the new boards get here. The old keyboards used to have midi in, out and thru where you could midi out of the master to midi in of slave 1 then thru/in/thru/in, etc and the master would play all devices simultaneously, but with ksit in and out, my Yamaha GX-76 midi'd out to Korg Microstation works but the organ module only plays when midi'd to the microstation.

Is there a way to program the midi on the PA500 so that it slaves to the P-95 but also transmit note information and sends it out to the module?

HELP!!!


Thanks.....

Jeff