This is what I suspect, that the audya should be on earlier than the Ketron instructions say but I was hoping that someone who has already updated would verify that the step by step instructions are incorrect. At what point do you hold down both F10 and Unplugged buttons and turn on Audya? Thanks for your opinion on this.
You are right.
1-After the update is done from the PC to the Audya4, you.. 2-Disconnect the cable either in the PC side or the Audya4 side,
3-Power OFF the audya4
4- Power ON the Audya4 holding down the F10 and Unplugged at the same time and let the software do the update ( you will see the LEDs in the left side flashing).
5- When it it finish, the Audya4 will ask you for a final power OFF/Power on and finish the update.
6- Them you will be ready to go.
Previous Topic
Index
