I suppose I too was confused when I posted my first response and still may be, but.....
If I understand your question, all you have to do is set up your "new" synths programs to match your 0w1. i.e. if program #32 on your 0w1 is a voice pad, write a voice program to the same location on your "new" synth. I believe you will find this to be more time consuming than inserting a program change and
there are easier ways. Providing your new synth has a built in sequencer, you can create a "sequence set-up" and disable program change... If the new synth has a "combination" or "performance" mode, you can create this set up in a similar fashion, again disabling program changes. However, regardless of which way you choose, you may find that the programming attributes (velosity, pressure, etc.) do not match you original and opt to re-record the entire track using the new program.