UBBFriend: Email This Page to Someone!

Synth Zone BBS   Kurzweil Discussion   Kurzweil Mark 12 Programming Voltage    profile | register | preferences | faq | search

Author	Topic:   Kurzweil Mark 12 Programming Voltage
jjdad Junior Member	posted 03-25-2007 06:44 PM             Hello. I just purchased a used Kurzweil Mark 12 piano. Hardly used. I was trying to update the firmware to the lastest version. The disk reads into the piano, then I get an error message saying "Error Bad Programming Voltage [FPV} I don't have a service manual. So any suggestions? Thanks! IP: Logged

All times are PT (US)	next newest topic | next oldest topic
Administrative Options: Close Topic | Archive/Move | Delete Topic
	Hop to: Select a Forum or Archive List of Forums: Category: General & Computer Related --------------------General DiscussionStudio & Recording DiscussionSynth & Midi Guitar ForumWanted To Buy & SellMIDI Sequencing & Keyboard StylesSamples, Loops & Grooves Forum Category: Software Chat Rooms --------------------PC Software & Hardware ForumMac Software & Hardware ForumSteinberg PC ForumSteinberg Mac ForumCakewalk & Sonar Forum Category: The Arranger Keyboard Forums --------------------General Arranger Keyboard ForumKetron ForumKorg Arranger Keyboard ForumGEM Keyboard ForumRoland Arranger Keyboard ForumSoftware Arrangers & SoftsynthsTechnics DiscussionYamaha Arranger Keyboard ForumThe Bar Category: Synths --------------------Akai DiscussionAlesis DiscussionCasio Keyboards DiscussionClavia DiscussionE-Mu DiscussionEnsoniq DiscussionKawai DiscussionKorg DiscussionKorg - Trinity, Triton, Prophecy, Z1Kurzweil DiscussionMoog DiscussionNovation DiscussionOberheim DiscussionRoland - General DiscussionRoland Groove Synths & ModulesRoland JV /XP/ XV SeriesSequential CircuitsWaldorf DiscussionYamaha Discussion List of Archives:

Powered by: Ultimate Bulletin Board, Version 5.42a
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 1999.