;; EX-800
Courtesy of JOHN SEPULVEDA Korg EX-800 Data Dump...=F0 42 21 01 10
F7
************************************************ For
Cakewalk just copy that and put it in the wincake.ini with the other dump shit
that looks similar. What it does is request all of the ex800's sounds. You must
have a sequencer able to send this inorder to do this.
THE FILTER MOD!!!
I have a mod for the Ex/Poly 800, by removing the
filter cutoff trimpot (VR2) (from the big green board not the little
brown board!!!!!!!) and putting a 100K audio taper pot in it's place you have a
nice front panel Filter cutoff knob!!!! Drill a hole in a nice place in the
front panel to put the pot. I used a big red knob on mine..... You can do the
same mod with the resonance (VR5) pot also. Sweet !!!!!!!!!!! The other
trimmers are for noise level, coarse tune, and fine tune. I did not find that
any of these were useful as knobs on the front panel for me.
Now that you cheezed some mods and sounds off me go check out my band
Matrix.
Warning: if you suck with a soldering iron, don't blame me if you fuck up you
poly/ex800. Also, I am not a free tech support service, so please do
not e-mail me asking how to get your sequencer to work with poly 800 and
your grandma's home organ. I don't mind you asking if your going to buy copies
of my band's cd though, then you will get any retarded questions answered.
. 
Get your own Free Home Page
