esq-m and librarian software

I recently purchased both an esq-m and the editor/librarian software. I was able to dump a bank of sounds from the synth into my computer, but have so far been unable to load any sounds back into the esq-m. I was told by the guy that sold me the librarian with around 2400 sounds that it should work fine despite being written for the esq-1, but is this in fact the case. BTW- I did check the midi output/input preferences in the software, and I checked that my basic recieve channel is 1. Is there some kind of menu command that needs to be toggled for the ESQ to recieve sysex stuff? Because I couldn't find one. Any help would be vastly appreciated.
Jason

What was the name of the editor? if its the same one I use for my esq1 its should support both the rack and KBD versions

The desktop name is ESQ-1 Librarian. The name as it appears when it loads is
Ensoniq Patch Librarian ESQ1
S.A.D Software, Copyright 1995
Jason

Each time the ESQm is powered down and back up, it reverts to "K+C+PC" in the MIDI receive menu, so you have to reset it to "KCPSYS" (one increment up) and then it should work fine. For some reason they thought they needed to design a safeguard to prevent accidental sysex overwrites.mn

Exactly like Mike says
I have the same editor for my ESQ1 if you still have probs