Posted by: Anonymous
ZR76 timing problems - 11/13/99 05:14 PM
Has anyone experienced timing disturbance with the ZR76 built-in sequencer?
Some kind of a little pause occurs when a sequence switch to another.
Does anyone know how to avoid it?
Thanks for your help.
Posted by: Cinda Private
Re: ZR76 timing problems - 11/25/99 12:25 PM
This same problem was present in its predecessor the MR-61. I don't think that there is much that can be done about it.
Posted by: buinu
Re: ZR76 timing problems - 11/26/99 05:36 AM
I have no experience with an Ensoniq product since the TS series so I do not know how or if their sequencers have changed since '93. On the SD1 and TS 10/12, there would be a delay only if the sequences used a different effect. Again, I don't know if you have already ruled this out, but you may check to see if a different fx is being inserted. If that is the cause, there is a way around it.
Posted by: rayleslee
Re: ZR76 timing problems - 12/22/99 09:14 PM
problems with sequence files linking "musically" are usually corrected by shaving time off the end of seq 1 or the begining of seq 2 - sometimes quantizing the first beat of seq 2 has worked - sometimes there's a little silence recorded at the end of seq 1
that needs to be erased - it depends on the music and your tenacity to solve the problem - I've done many large projects with the mr-76 as the center of my studio and it took time to get used to the quirks - It's well worth the effort.