I have some midi bass pedals and have considered using them. Is it possible to do that with LS or OMB. How might I go about that?
Scott, yes it is. I use the Roland PK5 Bass Pedals to play bass for my organ performances, e.g., NI's B4II.
Again, I would use a host software with a sampler and direct it via channel and port to the appropriate bass voices. It works well!!!
[This message has been edited by Frank L. Rosenthal (edited 07-24-2006).]
Posted by: abacus
Re: Midi bass pedals - 07/24/06 07:35 AM
The default channel when connecting a Midi pedal board is normally channel 3, so if you work on this, it should integrate with most instruments.
Hope this helps.
Bill
Posted by: Bernie9
Re: Midi bass pedals - 07/24/06 02:12 PM
Very interesting.
I have B4II, and was thinking of getting a second controller anyway,for the lower manual, and have midi pedals.
Would I use my Midisport 2x2 ? What about the midi from the bass pedals ?
I have been using arrangers and USB too long. I have forgotten my midi basics I'm afraid.
Bernie
Posted by: abacus
Re: Midi bass pedals - 07/24/06 10:57 PM
Hello Bernie
The 3 main default channels for keyboards/organs are usually. 1 = upper/right, 2 = lower/left and 3 = bass/pedal. (B4 follows the default channels)
Hope this helps.
Bill
Posted by: Bernie9
Re: Midi bass pedals - 07/25/06 01:09 AM
Sorry
I meant the physical connections. I would have three midi-outs. I have an old thru box, or maybe midi-merge ?
Posted by: abacus
Re: Midi bass pedals - 07/25/06 03:03 AM
Hello Bernie
What equipment are you using, and what midi connections are available on each unit. (IE the number of Midi In/Out/ thru sockets)
Also have a look at this link.
http://web.archive.org/web/2001122405054...s/midicnct.html Bill
Posted by: Bernie9
Re: Midi bass pedals - 07/25/06 06:03 AM
I HAVE B4II in Receptor(in/out/thru). It also has 3 USB in's. This is in addition to the above external equipment.
Posted by: Bernie9
Re: Midi bass pedals - 07/25/06 01:42 PM
I did learn that I can use one USB and one midi-in into Receptor.
Posted by: abacus
Re: Midi bass pedals - 07/25/06 09:56 PM
Hi Bernie
The easiest way is to use a 3 in to 1 Midi Merge Box.
If you have a USB controller that is supported by receptor, then you will only need a Midi Merge Unit for the controllers that have just the Midi connections.
Hope this helps.
Bill
Posted by: Bernie9
Re: Midi bass pedals - 07/26/06 02:05 PM
Thanks alot, Bill.
I ordered a Midiman Merge 2x2. That will handle my two midi outs into 1 midi in. When I get my other controller, it will be USB for sure.
Bernie