x1 output signal

Posted by: Janez

x1 output signal - 02/14/02 12:48 PM

Hello!
After 3 or 4 hours playing on my x1, the output signal decrease but I'm not 100% shure. Is it posible?
Thanks!
Janez



------------------
Posted by: Dnj

Re: x1 output signal - 02/14/02 01:17 PM

Are you playing thru an amp also?
Posted by: Janez

Re: x1 output signal - 02/14/02 01:45 PM

I playing without speakers on x1 (speakers off) directly on mix.

------------------
Posted by: DanO1

Re: x1 output signal - 02/14/02 03:32 PM

Check your cables .
Do you have a volumne pedal hooked up ?
Give us a little more ...........dano
Posted by: flowerssupply

Re: x1 output signal - 02/14/02 07:21 PM

I Never noticed a change. Also watch your left hand volume -- its set at 63 but while playing if you press the value + and - buttons the left volume decreases. These levels are set per style but I need to set them individually in single regs.
Q was decrease within same style ??? As Dano was saying Vol pedal ????if swell setting in (Arrenge Mode F4)is "ticked" it swells right hand side and if unticked it swells vol of whole instrument. I set it to "Swell" for changing right hand Vol only. Vol probs also if recording with vol pedal attached ie remove vol pedal if recording. Pierce Pierce