Posted by: tedstruk
Ensoniq SD-1 main board rework and battery test - 08/18/21 07:41 PM
I read the book about testing the battery with the preset+compare, and the battery reads 90... its supposed to be between 125 and 250. What is the value about?
My SD-1 had a jumper placed across one of the larger chips, and a small wire that goes from one of the chip pins to the other edge of the board. Are these factory reworks, or could they be the cause of my undervolt?
My SD-1 had a jumper placed across one of the larger chips, and a small wire that goes from one of the chip pins to the other edge of the board. Are these factory reworks, or could they be the cause of my undervolt?