Using Legacy Voices With The SD7

I downloaded some SD1 voices and tried to use them with my SD7. Nothing I did made the SD7 "see" the voices. Is this doable and how do you make use of such voices?

Deane

Hi Deane,

you're not on your own, I have tried this and I cannot get them to be seen by the SD7.

Really hope someone comes up with an answer.

Alan

Where could i get the SD1 voices ?

They will not work as the platform is completely different - even the styles have to be converted. I found it easier to make up new sounds from scratch - But I am lucky enough to have the old keyboards to compare which makes copying much easier. What sounds were you wanting?

Tonewheeldude,

There were no special voices I wanted or needed. The questions arose on a UK forum where people are trying to decide to buy or not to buy a SD7 or SD40 module. I own 2 SD7 keyboards and was trying to help them. The group wanted to know about backward compatibility much like Yamaha keyboards have had forever.

Seems like Italy would see the advantage in providing full backward compatibility with their products.

Deane

Asking an SD7 to load factory sounds from the SD1 is a bit like asking a PSRA3000 to load a factory sound from a PSR8000 its just not necessary as they are lower quality samples on the older model. If there are specific sounds they have in mind its very easy to create them using the custom voice editor. You also have to keep in mind - Ketron are very on the ball when choosing their technology platform. The SD7/40/9 are Ketrons 4th major technology change since the MS series.

Styles are a different matter though - the SD7 and SD40 are the most backward compatible models yet. I have succesfully converted styles (on the SD) going right back the the X1 with only minor tweeking needed (drum kit selection was different on some styles and the organ voice on lower 2 was sometimes an octave too low).

If your friends buy from the UK they get around 380 additional styles pre installed if required and if they ask when purchasing there are around 30 additional sounds for the SD7 so far (more being added)

I have just tried to use a couple of styles off Createasongstyle site and it stated it was converting the first one but nothing happened apart from locking up the keyboard so I had to switch it off. The file extension was .PAT No one from the forum said they had problems with them though so am I doing something wrong. Many thanks in advance for any help.
Bill

your welcome to send me the style to test - as its a third party style it may be corrupt.

Bill,
the SD7 will convert just about any of the .PAT files unless they came from the Audya. I just sent you a lot of styles I have converted from Ketron Legacy keyboards.

Deane

Bill,
I should have mentioned this before. There are styles you will find with the .PAT extension that came from yamaha, korg, Roland etc and someone converted them for Ketron keyboards. Many of these styles are rubbish and will not convert to the .KST format on our SD7s. Also, it is these styles that often cause a problem with locking up the SD7. So far, if I use the styles from older Ketron keyboards they convert easily and seldom cause any problems. Keep in mind though, Audya styles will not work on our SD7s.

Deane

Hi sir, just sent you a PM

Hmm, Nothing found other than this note?

Basically i have SD7, but would love some form of the guitar "Tremelo" voice from the like of the Sd1/Sd5. Anyone know if such a voice can be reproduced for the SD7 or purchased???

You got me on that one. Never heard or saw an SD1 or SD5. Not going to help you with the SD7 but for folks that have SD9/90/60 should be able to sample the older SDx units yo mentioned and get the sound that way.