SYNTH ZONE
Visit The Bar For Casual Discussion
Topic Options
#32188 - 11/11/02 09:23 AM New to X-1 Oriental
Anonymous
Unregistered


When I power up my X-1 it does not load the oriental automatically (but my friends unit does automatically load) Help Please!!
ALSO- is the X-1 110/220 switchable???

[This message has been edited by YoGaz (edited 11-11-2002).]

Top
#32189 - 11/13/02 08:22 AM Re: New to X-1 Oriental
George Kaye Offline
Senior Member

Registered: 11/24/99
Posts: 3281
Loc: Reseda, California USA
Here's what you need to do. Go to the hard disk folder that has the oriental sounds (you will know this because you will see 8 sound files in a folder). Next, select any one of the sounds and press the save/enter button. this will create a automatic load file in that folder. Next, after exiting back to the main screen press the save enter button again and this time press the function button next to the word "power on setup" then press the function button next to the word "execute". This last part is important, because you need to make sure that everytime you turn on the X1 it is going to power on to the folder in the hard drive which contains the autoload file. If for example, when you pressed the power on setup button you were at a different folder, everytime you turn on your X1 it will go to that folder which does not contain the autoload file and so you will not see it start to autoload. Make sure to have the proper folder active when you do the power on set up.
George Kaye
Kaye's Music Scene
Reseda, California
_________________________
George Kaye
Kaye's Music Scene
Reseda, California
818-881-5566
www.kayesmusicscene.com

Top

Moderator:  Admin, Ketron_AJ, Tonewheeldude 



Help keep Synth Zone Online