I'm using loops samples in drum2 (SD1 4.0c). I did everything by the book but when i'm turning on wave sync drum2 repeats the 1st beat over and over even though the loop is a full bar long. yes, I did define sample start end and loop and also pitch=sync and bar=1 gives me the right tempo. after spending some time i've found a way around it. I hit C3 key on 1st beat of every bar and hold it up to the end of that bar. it's not very easy because if i release too soon, there's a gap in the loop, but that's the only way i found. is that the way it ment to be? what am i doing wrong?
also, I only have room for 1 sample or 1 msp. I loaded 2 loops in a msp and I'm trying to sync using the above method. now the loop which resides at C3 syncs fine but the other one fall out of sync. is there a way to have all loops in a msp sync to tempo?

zzprod,

When using MSPs, it works best if all the original waves are sampled with the same bpm - not sure of the other part of your question - please rephrase...

1st part of my question refers to "wave sync" function - in the record pattern screen.
when turned on it automatically triggers the sample in C3 on every single beat. in other words, it counts 1,2,3,4.
is it possible to make it count (trigger) just the 1 of every bar?